Procovella self-adhesive

Usage

Windows, all types of furniture (furniture making), other delicate interior surfaces (tiles, mirrors, and much more), bathroom fittings, office furniture, kitchen fittings

Processing

Remove the release liner from the adhesive film. Stick it onto the desired, prepared surface. If necessary,
overlap the strips.

Note

The substrate must be permanently dry, clean and dust-free, as well as resistant to tension and compression, and must not contain any release agents. Waxed or varnished wooden and parquet floors, as well as old or heavily worn surfaces, must be checked with particular care. Due to the variety of materials, substrates and external influences, it is essential to carry out your own tests on site before use. There is a risk that the release film may not be removable without leaving residue or that surface coatings may peel off.

Protect the ground cover fabric from direct sunlight. The manufacturer accepts no liability for any damage that may occur.

Note

Our application recommendations are intended to assist the purchaser or installer. They do not relieve you of the responsibility to check, at your own discretion, whether our products are suitable for the intended application. Claims for damages and warranty claims cannot be accepted in the case of self-adhesive products. The ambient temperature when removing the film should be between +15°C and +50°C. The film must never be removed in frosty conditions. The rolls can be stored for up to 6 months under normal room conditions (+10 – +30°C) and must be protected from direct sunlight, heat, dust and moisture.

This protective fleece can be disposed of with normal household waste after use.